Control panels

The WELL range of control panels is designed to control submersible well electropumps, submersible draining electropumps or surface electropumps.
They are simple and provide full protection for your electropump.

• Single phase power supply: 100-240Vac 50/60Hz
• Three phase power supply: 310-450Vac 50/60Hz
• Level monitoring via filling or emptying probes
• Phase sequence/loss monitoring with light indicator
• Temperature monitoring via electropump Clicson
• Electronic monitoring of maximum current due to overload
• Electronic monitoring of minimum current due to dry running
• Automatic reset for minimum current alarm
• Float or pressure switch input
• Float switch alarm input
• Provision for starting capacitor (not included) for single-phase version
• Automatic - 0 - Manual (unstable) buttons
• DIP SWITCHES for:
  • Level probe alarm enable
  • Thermal cut-out delay
  • Alarm output set-up
  • Motor Clicson alarm reset enable
  • Filling/emptying operation
  • Float switch run/stop enable
  • Electropump on delay from 0 to 15 seconds after mains power return
• Green LED: electropump ON, mains power - circuit breaker on
• Red LED: probe level alarm, float switch level alarm, overload alarm, electropump Clicson alarm, minimum current alarm
• Cumulative alarm output 12 V (100 mA)
• Protection fuses for auxiliary and power circuits
• ABS box, IP 55
• ambient temperature -5 to 40°C
• relative humidity at 40°C: 50% (non-condensing)